This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Hozza
Quote from: Gaza07 on March 09, 2019, 10:02:52 pmThat looks cracking was it done in vase mode ?
Thank you and yeah in S3D
Very simple, pop the lid on which starts the process, once lid is covered in condensation remove lid and your part is vaped
I use one of these for vaping ABS prints:
Cheap, safe and easy to setup outside so no risk of fumes in the house.
Quote from: Gaza07 on September 03, 2018, 12:31:31 pm
Quote from: nate80 on August 31, 2018, 08:36:56 am
Had to print one in the Stronghero3d Rainbow PLA, the top is printed in Polyalchemy Elixir PLA
Still printing the screw
Really nice quality Gaz, plus a good resin test
Printed with Stronghero3d rainbow PLA
Depends on the resin but you are looking at round £25 for 500ml
Unfortunately I have to sell my D100 due to I've found out I have an allergic reaction to the resin fumes, even though you can't smell them with the lid one.
In the past I used a brand that was on cardboard spools, never was a issue and I don't keep PLA sealed.
Would use it now but the price went through the roof and couple of years ago so made the switch.
Have you printed with it Gaz?
I've taken the plunge at that price
Long range extruder? Do you mean bowden extruder.